Digitool Solutions TC Series Torque Tester

How confident are you that every torque wrench you use is working and calibrated correctly? What if you could guarantee your wrenches are working and all your applications are 100% tightened properly! Now you can with our “TC” series torque checkers and save thousands in unneeded wrench repair services or job reworks.

They reduce down time in assembly and automotive repair by allowing in-house checks of torque calibration. The accuracy better than ±1% of reading between 10% and 100% of full scale in both CW and CCW directions, this checker insures that any torque wrench is correctly set and in calibration.

Available in 3/8 and 1/2” drive and four torque ranges covering 30 “in-lb to 250 “ft-lb”, and 3.40 to 340 Nm, these checkers facilitate all square-drive sizes in compliance with the ASME B107.29-2005 Type 1 Class C . With certified National Institute of Standards and Technology ( N.I.S.T.) traceability, this checker is qualified to provide calibration of all torque instruments in the 4% or lower precision range.

From the shop floor to the tool crib, you now have an affordable way to control all your torque applications. The TC checker is low cost, simple to use and easy to set up with no training required. Distribution and Jobbers can even offer a verification service to their customers with this tool.

The cost of calibration and repair can average $80 to $100 per tool whether it is needed or not. Know you need it before you send it! Digitool Solutions patented technology is changing the way you use Torque every day. Check us out at www.digitoolsolutions.com or call us at 909.591.9581 and see what we can do for you.